Viimati aktiivne: Mitte kunagi
Pole sisse logitud. [
Logi sisse
-
Registreeri
]
OTSING
|
Tänased postitused
|
Kuulutused
|
Reeglid
|
MOBIILIVAADE
|
KLUBIKAART
Liikmed
|
Abi
|
Statistika
|
Chat
Kiirotsing:
Eesti Audi Klubi foorum
»
S - Audid
»
20vT - tuuning
»
Toitesüsteem (pihustid, regulaator, pump..)
» Vasta
Vasta
Kes saavad postitada?
ja
Kasutajanimi
Soovid registreerida?
Parool:
Unustasid parooli?
Pealkiri:
Vormindamine:
Tavaline
Edasijõudnud
Abi
Andale Mono
Arial
Arial Black
Book Antiqua
Century Gothic
Comic Sans MS
Courier New
Georgia
Impact
Tahoma
Times New Roman
Trebuchet MS
Script MT Bold
Stencil
Verdana
Lucida Console
-2
-1
1
2
3
4
5
6
White
Black
Red
Yellow
Pink
Green
Orange
Purple
Blue
Beige
Brown
Teal
Navy
Maroon
LimeGreen
Postitus:
HTML on Väljas
Emotikonid on Sees
BBkood
is Sees
[img] kood on Sees
[quote][i]Algselt postitas: Maku[/i] [url=http://www.golenengineservice.com/html/fuel_pressure.html]Adjusting the Fuel Pressure[/url] Igaks petteks viskan copy/paste siia, kui juhuslikult see leht ära peaks kaduma. Adjusting the Fuel Pressure on GM's Electronic Fuel Injection by Chad Golen In this article we will discuss how to properly adjust the fuel pressure on a GM fuel injected engine and how to gain the most power through the adjustment. By adjusting the fuel pressure you are looking for maximum power from your new high performance engine and this will take some trial and error to achieve. In order to make the adjustment you will need the following tools: A fuel pressure gauge that will screw onto your Schrader Valve on your fuel rail and a small wrench to turn the screw on the regulator. Step #1 You will need to screw the fuel pressure gauge onto the Schrader Valve that is located on your fuel rail, (see picture A) make sure that it is tight to avoid any leaks and or fires. Once the gauge is installed turn the ignition key to the on position and check for leaks at the Schrader Valve. Step #2 Start the engine and let the idle level off and then disconnect the vacuum line that goes to the regulator (see picture B), make sure that you plug the rubber vacuum line so it does not leak vacuum while you are making the adjustment, [b](you only care about the fuel pressure reading with the vacuum line disconnected at idle).[/b] Step #3 Take the reading and make the adjustment to 46 lbs (see picture C). Step #4 You will need to drive the vehicle and take notes as to how it is performing, I recommend driving it for a little while so you know exactly how the engine and vehicle react. Once you are familiar with the engines performance adjust the fuel pressure up 2 lbs at a time taking notes as to the performance gain or loss and finally end your adjustment at max power. [/quote]
Keela emotikonid?
Kasutada allkirja?
Lülita BBkood välja?
Saa e-mailiga teatis vastustest?
Teema ülevaade
See on pikk teema,
klõpsa siia, et seda vaadata
.
Eesti Audi Klubi foorum
»
S - Audid
»
20vT - tuuning
»
Toitesüsteem (pihustid, regulaator, pump..)
» Vasta
XMB Audi Club Edition
Täiendanud: indro, klem, j6mm & diversion @ 2002-2020
Eesti Audi Klubi ei vastuta foorumis tehtud postituste eest.
[Päringuid:
22
]
[PHP:
30.3%
- SQL:
69.7%
]