Viimati aktiivne: Mitte kunagi
Pole sisse logitud. [
Logi sisse
-
Registreeri
]
OTSING
|
Tänased postitused
|
Kuulutused
|
Reeglid
|
MOBIILIVAADE
|
KLUBIKAART
Liikmed
|
Abi
|
Statistika
|
Chat
Kiirotsing:
Eesti Audi Klubi foorum
»
S - Audid
»
20vT - tuuning
»
Set-up lahendused
» Vasta
Vasta
Kes saavad postitada?
ja
Kasutajanimi
Soovid registreerida?
Parool:
Unustasid parooli?
Pealkiri:
Vormindamine:
Tavaline
Edasijõudnud
Abi
Andale Mono
Arial
Arial Black
Book Antiqua
Century Gothic
Comic Sans MS
Courier New
Georgia
Impact
Tahoma
Times New Roman
Trebuchet MS
Script MT Bold
Stencil
Verdana
Lucida Console
-2
-1
1
2
3
4
5
6
White
Black
Red
Yellow
Pink
Green
Orange
Purple
Blue
Beige
Brown
Teal
Navy
Maroon
LimeGreen
Postitus:
HTML on Väljas
Emotikonid on Sees
BBkood
is Sees
[img] kood on Sees
[quote][i]Algselt postitas: Maku[/i] Jamo: [i]IMO You need to consider more about torque and where in the rev range it's distributed than out and out bhp to that end [b]as long as you limit low end torque to sensible levels you will be fine[/b] [/i] A80Avant: [i]regardless of hp or whp, more than 550Nm(roughly) of crank torque coming at about 3000rpm can possibly bend the rods. If it appears at 4000rpm, its safe[/i] GazzaG60: [i]how can you define a safe limit? its not possible. some parts have been treated well others not. some are high milers so have mores stresses work ed out of them. if the limit you say is 400whp and you go 390 and bend stuff its purely your fault for believing something. why trust a xxx value engine and build on heresay and finite thresholds. [b]jamo is correct torque and fast acting low end torqu is the killer[/b]. id say on the holset you may be ok. maybe. i wouldn't risk the block on it. Also cant see the point in detuning a setup to avoid torque otherwise it may as well be a more lowly setup.[/i] http://www.s2forum.com/forum/showthread.php?t=43756 [/quote]
Keela emotikonid?
Kasutada allkirja?
Lülita BBkood välja?
Saa e-mailiga teatis vastustest?
Teema ülevaade
See on pikk teema,
klõpsa siia, et seda vaadata
.
Eesti Audi Klubi foorum
»
S - Audid
»
20vT - tuuning
»
Set-up lahendused
» Vasta
XMB Audi Club Edition
Täiendanud: indro, klem, j6mm & diversion @ 2002-2020
Eesti Audi Klubi ei vastuta foorumis tehtud postituste eest.
[Päringuid:
22
]
[PHP:
31.6%
- SQL:
68.4%
]