Viimati aktiivne: Mitte kunagi
Pole sisse logitud. [
Logi sisse
-
Registreeri
]
OTSING
|
Tänased postitused
|
Kuulutused
|
Reeglid
|
MOBIILIVAADE
|
KLUBIKAART
Liikmed
|
Abi
|
Statistika
|
Chat
Kiirotsing:
Eesti Audi Klubi foorum
»
S - Audid
»
V8 & V8 BiT - (4.2 V8 ja 4.2 V8 BiT)
»
RS6 4.2 biturbo ostuabi, informatsioon ja edasiarendus
» Vasta
Vasta
Kes saavad postitada?
ja
Kasutajanimi
Soovid registreerida?
Parool:
Unustasid parooli?
Pealkiri:
Vormindamine:
Tavaline
Edasijõudnud
Abi
Andale Mono
Arial
Arial Black
Book Antiqua
Century Gothic
Comic Sans MS
Courier New
Georgia
Impact
Tahoma
Times New Roman
Trebuchet MS
Script MT Bold
Stencil
Verdana
Lucida Console
-2
-1
1
2
3
4
5
6
White
Black
Red
Yellow
Pink
Green
Orange
Purple
Blue
Beige
Brown
Teal
Navy
Maroon
LimeGreen
Postitus:
HTML on Väljas
Emotikonid on Sees
BBkood
is Sees
[img] kood on Sees
[quote][i]Algselt postitas: Maku[/i] [url=http://www.rs6.com/showthread.php/21207-My-story-with-H-amp-R-springs-and-DRC-shocks]My story with H&R springs and DRC shocks[/url] [i]I decided to lower my car Did factory recall on shocks. Bought set of springs H&Rs Sport setup. H&R developed their RS6 setup with old shocks, new ones as you know sit higher, tons of claims including two of our cars. I installed H&R on stock DRC set up. Nice ride but rear looks ugly. Way too high. I could not understand why they had to make it 1.5 drop at a front and 1.0 rear when all prior a6 setups are 1.7/1.5 and 1.9/1.5 So, question was 1. will the 4.2 set up fit. 2. to figure the difference in weight between 4.2 a6 and RS6 3. Should it be Sport or Race setup they have for 4.2 RS6 vs 4.2 door stickers shows same front weight and 60lbs heavier in rear. Possibly because of battery and additional cooler. [b]So I bought H&R Race setup for A6 4.2 quattro. And got what I wanted. More stable and better looking ride.[/b][/i] ____________________________ [i]Do not do this mod! H&R Race springs from an A6 4.2 are too low when mounted in DRC shocks! DRC line interferes with axle in front and Hotchkis rear sway bar hits the rear axle. I clearly would have not done this mod if this had been reported by the one who started this thread. I guess I'm going back to stock springs. Lesson learned the hard way.[/i] [/quote]
Keela emotikonid?
Kasutada allkirja?
Lülita BBkood välja?
Saa e-mailiga teatis vastustest?
Teema ülevaade
See on pikk teema,
klõpsa siia, et seda vaadata
.
Eesti Audi Klubi foorum
»
S - Audid
»
V8 & V8 BiT - (4.2 V8 ja 4.2 V8 BiT)
»
RS6 4.2 biturbo ostuabi, informatsioon ja edasiarendus
» Vasta
XMB Audi Club Edition
Täiendanud: indro, klem, j6mm & diversion @ 2002-2020
Eesti Audi Klubi ei vastuta foorumis tehtud postituste eest.
[Päringuid:
22
]
[PHP:
36.5%
- SQL:
63.5%
]